Difference between revisions of "Brooder Arduino"
(→Coding) |
(→Coding) |
||
Line 1: | Line 1: | ||
==Coding== | ==Coding== | ||
− | <source lang=" | + | <source lang="c++"> |
#include <OneWire.h> | #include <OneWire.h> | ||
#include <DallasTemperature.h> | #include <DallasTemperature.h> |
Revision as of 12:16, 16 March 2017
Coding
<source lang="c++">
- include <OneWire.h>
- include <DallasTemperature.h>
// Data wire is plugged into pin 2 on the Arduino
- define ONE_WIRE_BUS 2
// Setup a oneWire instance to communicate with any OneWire devices // (not just Maxim/Dallas temperature ICs) OneWire oneWire(ONE_WIRE_BUS);
// Pass our oneWire reference to Dallas Temperature. DallasTemperature sensors(&oneWire);
void setup(void) {
// start serial port
Serial.begin(9600); Serial.println("Dallas Temperature IC Control Library Demo");
// Start up the library
sensors.begin(); pinMode(11,OUTPUT); }
void loop(void)
{
// call sensors.requestTemperatures() to issue a global temperature // request to all devices on the bus
Serial.print(" Requesting temperatures..."); sensors.requestTemperatures(); // Send the command to get temperatures Serial.println("DONE");
Serial.print("Temperature for Device 1 is: "); Serial.print(sensors.getTempCByIndex(0)); // Why "byIndex"? // You can have more than one IC on the same bus. // 0 refers to the first IC on the wire
if (sensors.getTempCByIndex(0)>25.5 && sensors.getTempCByIndex(0)<27) { digitalWrite(11,HIGH); } else{ digitalWrite(11,LOW); }
} </source>