Difference between revisions of "Brooder Arduino"
From RAWiki
(→Coding) |
|||
(5 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
− | + | *Note: this is code for connecting to a Dallas Temperature Sensor. By default, temperature is measured in Celsius. | |
− | < | + | <pre> |
#include <OneWire.h> | #include <OneWire.h> | ||
#include <DallasTemperature.h> | #include <DallasTemperature.h> | ||
Line 37: | Line 37: | ||
Serial.print(sensors.getTempCByIndex(0)); // Why "byIndex"? // You can have more than one IC on the same bus. // 0 refers to the first IC on the wire | Serial.print(sensors.getTempCByIndex(0)); // Why "byIndex"? // You can have more than one IC on the same bus. // 0 refers to the first IC on the wire | ||
− | if (sensors.getTempCByIndex(0)>25.5 && sensors.getTempCByIndex(0)<27) | + | if (sensors.getTempCByIndex(0)>25.5 && sensors.getTempCByIndex(0)<27) //ADJUST TEMPERATURE PARAMETERS HERE |
{ | { | ||
digitalWrite(11,HIGH); | digitalWrite(11,HIGH); | ||
Line 46: | Line 46: | ||
} | } | ||
− | </ | + | </pre> |
Latest revision as of 11:27, 21 March 2017
- Note: this is code for connecting to a Dallas Temperature Sensor. By default, temperature is measured in Celsius.
#include <OneWire.h> #include <DallasTemperature.h> // Data wire is plugged into pin 2 on the Arduino #define ONE_WIRE_BUS 2 // Setup a oneWire instance to communicate with any OneWire devices // (not just Maxim/Dallas temperature ICs) OneWire oneWire(ONE_WIRE_BUS); // Pass our oneWire reference to Dallas Temperature. DallasTemperature sensors(&oneWire); void setup(void) { // start serial port Serial.begin(9600); Serial.println("Dallas Temperature IC Control Library Demo"); // Start up the library sensors.begin(); pinMode(11,OUTPUT); } void loop(void) { // call sensors.requestTemperatures() to issue a global temperature // request to all devices on the bus Serial.print(" Requesting temperatures..."); sensors.requestTemperatures(); // Send the command to get temperatures Serial.println("DONE"); Serial.print("Temperature for Device 1 is: "); Serial.print(sensors.getTempCByIndex(0)); // Why "byIndex"? // You can have more than one IC on the same bus. // 0 refers to the first IC on the wire if (sensors.getTempCByIndex(0)>25.5 && sensors.getTempCByIndex(0)<27) //ADJUST TEMPERATURE PARAMETERS HERE { digitalWrite(11,HIGH); } else{ digitalWrite(11,LOW); } }