Incubation

From RAWiki
Revision as of 13:50, 27 January 2015 by Ahoussney (Talk | contribs) (Bulbs as heating element)

Jump to: navigation, search

Incubation is the process of creating an artificial environment for hatching eggs, usually of birds of various species, primarily chickens, ducks, turkeys and geese.


Design of incubation systems

Heating element

Keeping the incubator warm enough for chicks can be accomplished through a variety of heating methods. Early incubators employed a kerosene wicked lamp with a bi-metallic strip thermostat that adjusted the height of the flame. Today's heating elements can be a variety of types. Perhaps the simplest of which is the use of common incandescent light bulbs and their fixtures.

Redundancy

It's important to build an incubator with a high degree of reliability in order to protect the lives of the unborn animals that are being hatched. With light-bulb heating, this is accomplished through redundancy, in other words, if a bulb were to burn out, there should be enough heating power (wattage) in the bulbs that remain to maintain the proper incubator temperature. This means that at least two bulbs should be used.

Bulbs as heating element

For incubators that will be used frequently, one recommended strategy to get the most out of lightbulbs used as heating elements is to connect bulbs in a minimum of two sets of two bulbs. Within each set of two bulbs, the two bulb are connected to the other in series rather than the typical parallel arraignment. The two sets are then connected to each other in parallel.

With two bulbs connected in series the voltage (and therefore the wattage) of each bulb is cut in half. This dramatically reduces the color temperature of the bulbs increasing the proportion of the energy released as heat and decreasing the amount of visible light given off. The second effect of this decrease in wattage is a dramatic increase in the life of the bulb, causing the filament of the bulb to last over ten times as long as it would under the normal voltage.

The two sets of two bulbs function in parallel so that, increased bulb life, lower color temperature and redundancy are achieved.

This technique is not necessary in small incubators or those that are infrequently used.

Thermostats for incubators

Humidity controls

Egg turning